1/28 2WD indoor RACER / READYSET
JR128-R01 series models
are ultra small high performance 2WD indoor racing
cars with a lot of very advanced opportunities for fine tuning and car setup,
you might find very surprising in a car of this very small size.
9 built-in ball bearings,
an adjustable ball differential with 64dp fine pitch and a
1S / 3.7V Lipo battery + charger make you really ready to race out of the box.
The cars are already
equipped with a 12mm micro servo for steering, a small
2.4 GHz receiver and an ESC (Electronic Speed Controller) running with
1S / 3.7V Lipo batteries, providing 5.5V current for receiver and steering.
Various other commercially
available steering servos, micro receivers and micro
car ESCs for brushed or brushless motors from other brands can be built in and
used in this car. (Attention: Do not use motors with less than 40 turns (40T)
togehter with this ESC, to avoid damage of the ESC!)
Ask your dealer for our
brushless motor and ESC - system and for our 2S Lipo batteries,
if you need 8.4V power supply for your preferred electronics.
The chassis offers the following features:
at front suspension adjustable in three positions: 1.1°, 2.7°, 4.4°.
at front suspension left and right adjustable: from 0° to -2.5°.
· Toe-in /
Toe-out adjustable at: 0°, +1°, +2°, -1°, -2°.
limits at front suspension free adjustable.
springs at front suspension.
clearance front and rear adjustable on 4 levels in steps of 0.7mm.
damper with spring and droop-spring fully adjustable.
with springs for tweak adjustment.
scale body holder adjustable in height with included washers.
· Second rear scale body holder for wider scale bodies included.
· Front scale body holder set adjustable to most scale bodies from
for wide front and 98mm or 102mm wheelbase.
Content of the Box:
assembled Ready to Run JR128-R01 PRO RC Car:
Resistance Plastic Chassis
Design GT01 Body
· 9x Ball
Differential (V-Groove PN)
Standard Motor / 130 Class
· FS-GT2 /
2.4GHz digital proportional Receiver
· 1S / 3.7V
programmable brushed ESC
Polymer (Lipo) Battery:
· 1S / 3.7V
/ 840mAh / 25C Lipo Battery
for JR128-R01 indoor Racer
Decal for Car Body
for Lipo Battery:
· 1S / 3.7V
/ Lipo Charger
1A charging Current
Parts and Tools (8 Bags):
Hex-Wrench-1.5mm; +3 different plastic Tools
· Front Body-Holder-Adjustment-Set
for many other Car Bodies
adjustment Parts and Washers
Servo-, Rear Body-Holder and Adjustment Parts
Pinions and replacement Gear for Change of Car-Speed
· Steel- and Replacement Parts and Springs for Change of Setup
· O-Rings for Replacement
· Screws for Replacement
2.4 GHz digital proportional Radio
2channels; Model type: car / boat
· RF power:
less than 20dbm; Modulation: GFSK
type: digital; Sensitivity: 1024
voltage warning: yes (less than 9V)
· DSC port:
yes (3.5mm); Charger port: yes
12vdc (1.5AA*8); Weight: 328g
159*99*315mm; Color: black
8x AA-Batteries for Transmitter required, but not included!