Shopping Bag0 item(s) in cart/ Total: $0
LoCo RC Futaba S-FHSS Nano V2 4CH Gyro RX

LoCo RC Futaba S-FHSS Nano V2 4CH Gyro RX

review
0
0
5
Your Price: $59.99
Retail Price:$99.99
Your Savings:$40.00(40%)
In Stock
Part Number:LCRC8018
help
*We'll ask for shipping info at checkout

Features:

1. FUTABA S-FHSS protocol compatible

2. High performance CPU enhance precision control feeling

3. 4 channel servo signal

4. Micro size (19mm x 12mm x 7mm)

5. Operating Voltage 3.5V – 8.5V

6. Weight 1.25g

7. Internal GYRO function

 

Binding:

1. Power on the receiver. Press the BIND button until the blue LED flashing quickly(BIND mode)

2. Put the transmitter into bind mode. The receiver’s led will flash slowly when the binding is successful.

3. Disconnect receiver’s power and reconnects the power cable to the receiver. Now it should work normally.

 

Internal GYRO sensitivity setup:

The CH3 signal is used to set up the GYRO sensitivity and servo direction. When the CH3 signal is less than 1.4ms, the servo direction is left, the gyro sensitivity is changed from 0% to 100% according to the CH3 the signal from 1.4ms to 1ms. When the CH3 signal is greater than 1.6ms, the servo direction is right, the gyro sensitivity is changed from 0% to 100% according to the CH3 signal from 1.6ms to 2ms. When the CH3 signal is between 1.4ms to 1.6ms, the internal GYRO function is disabled.

 

CH1 output End Point setup:

1.    Change CH3 signal to middle point(1.4ms to 16.ms)to disable the GYRO function. The red and blue LED will be both off.

2.    Turn the steering to the left endpoint you want, press the BIND button to record the left endpoint, the red led will flash about 2 seconds then turn off.

3.    Turn the steering to the right endpoint you want, press the BIND button to record the right endpoint, the red led will flash about 2 seconds then turn off. 

Recently Viewed Items