Suber C9 Rear Wing Set Assembly Guide:
Deburr with cutter knife if needed.
Tighten Screws Slowly! Use the black screws to build the wing.
Take double sided adhesive tape to fix the wing to the body.
Align the wing at the body into right position,
Then drill two holes with 1.8mm drill bit into the back fenders.
Use the silver screw to fix the wing complete to the body.
Use sandpaper to sand the inside of the back fenders. Clean up with alcohol,
Glue carbon stability plates in with super glue.
Get more stiffness to the back fenders.
All set-parts are paintable.